Kongsberg Simrad MF90, Руководство по установке

Страница: 269 / 426

476671/B
267
• The vessel is berthed or at sea.
• Neither tools nor instruments are required.
The relevant offset values can normally be taken from the vessel drawings.
Context
The MF90 system is provided with a built-in motion sensor to provide electronic
stabilization of the sonar beams. It is placed inside the Motor Control Unit. The motion
sensor measures the roll and pitch movements of the vessel.
Note
If you want to use the built-in motion sensor, you do not need to enter any offset values.
If the hull unit has been installed with the Motor Control Unit pointing straight aft, you do
not need to enter any rotation values. If the unit faces in any other direction you must
compensate for this by typing the relevant value for
Rotation Around Z
.
For improved operational accuracy, an external motion reference unit (MRU) can be used.
Offsets
The offset values specify the physical location of the motion reference unit relative to
the reference point (origin). The relevant offset values can normally be taken from
the vessel drawings.
Rotation
The values for rotation around the X, Y and Z axis are used to compensate for any
misalignments made during the physical installation of the motion reference unit.
Such misalignments occur if the sensor is not placed in parallel with the vessel’s
horizontal and/or vertical planes. We strongly recommend that you install your motion
reference unit so that all rotation angles can be set to 0 (zero).
The required accuracy of the offset and rotation angles depends on the accuracy requirements
for the echo data.
Note
Correct values for motion sensor rotation are critical for the sonar performance.
The motion sensor offset values (its physical location relative to the vessels' coordinate
system) are not important for sonar operation.
The Kongsberg Seapath ® - and other GPS systems - allow you to define the MRU location in
the positioning system. If this is done, the MRU offset values in the MF90 system must be
set to 0 (zero) to avoid "dual compensation". The rotation angles are normally not recorded
Setting to work