Kollmorgen 4/13/2012
Regulatory
Information
S200 Position Node Installation Guide
57
APPENDIX B - REGULATORY INFORMATION
B.1 C
ONFORMANCE
R
EQUIREMENTS
The equipment described herein has been developed, produced, tested and documented in accordance with the
corresponding standards. Use conforming with requirements means that the safety recommendations and
warnings detailed in this manual are complied with and that the applicable regulations for safety (machine
directives, etc.) and noise suppression (EMC Directives) are observed while operating the drive. At the end of its
lifetime, dispose of or recycle the drive according to the regulations applicable at that time.
B.2 CE
A
PPROVAL
The CE initials confirm that the S200 drives satisfy all requirements of CE Directives. However, the equipment is
not ready to operate without additional installations (cable, motor, etc.). Thus, all necessary tests and
measurements had to be made on a typical installation. The test installation with all peripheral devices, as well as
the test results and measurements are recorded in detail in documentation that is available from the manufacturer
on request.
B.3
CE EMC C
OMPLIANCE
NOTE
If the connection method on your machine is different from the ones pictured in this
manual, or in the event of use of components other than those specified, adherence to CE
interference limit values cannot be guaranteed.
The machine builder should incorporate good EMC installation and wiring practices in the
machine design. Some machine designs require more EMC consideration than others. For
example, a multi-axis machine generates more noise than a single-axis machine.
Therefore, multi-axis machines may require additional noise reduction techniques, such as
a metal enclosure or clamping of cables shields to an RF ground.
B.3.1. CE
Test
Setup
AC MODELS S2XX6X-VTS
1
2
3
4
5
6
7
8
9
10
6
6
