121
of the left side stake.
ROFS:
The key is use in setting out the right side stake. Press it to display the offset and the height
difference of the right side stake.
+CHG:
The key is use in increasing the chainage.
-CHG:
The key is use in discreasing the chainage.
19.2.4 Slope Setout
Slope setting-out can be performed as part of the Alignment setout option. After defining vertical curve and
horizontal alignment in the “Define Roads Menu”, it is possible to perform slope setting-out. Press
F4
(SLOPE)
key, Slope Setout will be displayed.
The left and right slopes may be entered for both cut and fill. Enter the required slopes using positive numbers for
both cut and fill. The software selects the appropriate slope from the table depending on whether the situation is on
the left or right and in cut or fill.
Cut or fill is determined by the estimated level at the offset of the hinge point. If the level is above the level of the
hinge then the cut slope is used, otherwise the fill slope is used.
Slope set out
(1
：
N)
Cut L 0.000
Fill L 0.000
Cut R 0.000
Fill R 0.000
OK
Содержание KTS440 L Series
Страница 9: ...9 3 NOMENCLATURE ...
Страница 10: ...10 ...
