Kodiak LGSG13HC, Руководство оператора

Страница: 19 / 27

GSG13HC
Maintenance Procedures
This section encompasses two general types of maintenance: 1. Preventative Maintenance and 2. General Service.
The first refers to regularly scheduled routine care of the stump grinder, such as cleaning and lubrication. The
second provides information on common procedures, such as changing flails, and adjusting the drive belt that are to
be performed as needed.
By following the Inspection Schedule below BEFORE and AFTER each use of the stump gringder appropriate actions
can be taken to extend the service life of the machine and reduce any costly repairs and unnecessary downtime for the
unit.
! All service should be performed by trained
technicians.
A.Inspection Schedule
The following list aims offer some basic guidelines to performing a detailed inspection BEFORE and AFTER each use.
Certain checks will require some disassembly, i.e. the removal of the drive guard, to perform. Depending on various
environmental conditions and frequency of use, other inspection points may have to be added for each machine.
Item Yes No
Is the engine oil filled to recommended levels? Consult Engine Manufacturer's Manual.
Is the gear box well lubricated and clean?
Is the engine air cleaner properly attached and clean? Consult Engine Manufacturer's Manual.
Is the drive belt tension set properly?
Is the splitting wedge well-sharpened and in good repair?
Are the safety warning labels and other decals clearly identifiable and legible?
If not, ensure that fresh decals will be re-applied prior to use for operator safety.
B. Preventative Maintenance Procedures
Maintaining a regular cleaning and lubrication schedule as well as taking time to perform preventative
maintenance procedures will prolong the service life of the LGSG13HC. The following are guidelines to setting up
a regular maintenance routine for thestump gringder
1.Cleaning the
i. After each use, the stump grinder, in particular the cutting wheels, cutting teeth and underneath the rubber skirt,
should be cleaned and washed of any dirt or debris that may be trapped in the unit.
ii.When using a power pressure washer to clean the unit, DO NOT USE ANY MACHINE RATED HIGHER
THAN 1000 PSI.
iii.Beware of damaging any warning decals and labels, as well as the drive belt, bearings and engine.
Limit direct spray on these objects to help prevent their wear and tear.
iv. For easier access to cleaning the stump grinder, the machine may be tipped on its engine guard for NO
MORE THAN 2 MINUTES. Engine damage may result from gasoline flowing into the crankshaft due
to prolonged tipping.
L
17