Kodiak LGSG13HC, Руководство оператора

Страница: 17 / 27

Opeation Procedures cont'd
5. If there is a need to reposition the stump grinder, follow these directions:
a. Release the operator presence loop and press the start/stop switch to turn the machine off and follow the
engine manufacturer's instructions on shutting down the engine. Ensure that the cutter wheel has come to
a complete stop. NEVER LEAVE A RUNNING STUMP GRINDER UNATTENDED.
b. Remove the stump grinder away from work area and set the break lever.
c. Clear the work area of any wood chips or debris prior to repositioning the stump grinder.
Always ensure that work area is clean and free of
excessive wood chips for safe operation. Stop
machine and wait until cutter wheel has come to a
complete stop. If a large amount of chips have built
up, rake them out of the work area.
d. Release break lever, reposition the machine to the remaining outside edge of the stump (see Figure 5).
e. Apply brake, start engine and machines as previously described and continue to grind the stump until
it is level with the ground.
f. Repeat process until entire stump is level with the ground (see Figure 6).
Fig. 5 Positioning cutter wheel to outside edge of stump
On large stumps, DO NOT allow wheels of machine
to fall into hole. Reposition machine or fill hole with
dirt or chips.
g. If a large quantity of chips have built up in work area, stop the machine and clear work area of chips
and foreign objects.
Fig. 6 Grind until stump is level with ground
15