Kodiak LGSG13HC, Руководство оператора

Страница: 12 / 27

Machine Overview
The following is a list of important control and operation mechanisms with which the operator must be familiar PRIOR to
using the stump grinder. Failure to do so may result in severe injury and/or fatality to the operator and others and may lead
to reduced machine life or damage to the stump grinder.
a.Start/stop switch- The Start/stop switch is located on the control panel that is attached to the handle.
The Start/stop switch turns on and off the machine. Pull the switch to start the machine and push it to stop
the machine. In the event of an emergency, push the Start/stop switch immediately!
b.Operator presence loop- The operator presence loop enables the engine to run when the operator presses
either end of the loop against the handle of the machine. This design is a safety mechanism which functions
as a dead man's grip. Releasing the loop will deactivate the engine so as to disengage the stump grinder
when there is no operator or other external force to engage the loop.
c.Brake Lever Handle- The brake lever handle locks the braked wheel. Shift the brake lever handle into an
upright position to lock the braked wheel.
d.Heavy-Duty chip Curtains- The chip curtains protect the operator from flying debris. Do not operate the
stump grinder if chip curtains are frayed, torn, of missing.
e.Square Foot Rest- The square foot rest increases the stability of pull-start models. To start a pull-start model,
place foot on square foot rest while pulling on starter rope and pushing down on handle.
f.Handle Height Adjusting Pin- The handle height adjusting pin allows the operator to adjust the handle for
comfort or different job conditions. Caution: Do not attempt to adjust handle height while engine is running or
cutter wheel is rotating.
g.Belt Guards- The belt guards protect the operator and extend belt life. Before using the stump grinder, operator
should ensure that belt guards are secure and in good condition.
h.Cutter Wheel Housing- the cutter wheel housing is a metal shell that covers the top of the cutter wheel.
Before using the stump grinder, operator should ensure that the cutter wheel housing is secure and in good
condition (e.g., free of cracked welds, dents, and thin spots).
i.Cutter Wheel Assembly must be kept in good condition (e.g., with sharp teeth, all bearings and pocket bolts
securely in place, and good pocked condition).
10