Kodiak LGSG13HC, Руководство оператора

Страница: 16 / 27

B. Starting the
LGSG13HC
1. Ensure that the cutter wheel off the ground before starting engine. Follow instructions in the engine m
anufacturer's manual to properly start the engine.
2. Start the machine by pulling the start/stop switch located on the control panel.
3. Grasp the operator presence loop and press it tightly against the handle.
Fig.2: Using the operator presence loop
Machine will not operate unless operator presence
loop is pressed against the handle. Releasing the
loop will disable the machine (see Figure 2)
DO NOT TAMPER WITH OR DISABLE OPERATOR
PRESENCE SYSTEM. IF ENGINE RUNS WITH OP-
ERATOR PRESENCE LOOP IN DISABLED POSITION,
DO NOT USE MACHINE UNTIL IT IS REPAIRED.
4. Activator engine by pulling cord while resting foot on square foot rest and
pushing down on handle, see engine manufacturer's manual for further
instruction on how to start engine.
Opeation Procedures cont'd
C. Stump grinding on Level Surfaces
1. Allow engine to warm up to operating temperature (see engine manufacture's manual).
Increase speed to full throttle once engine is sufficiently warm.
2. With handle parallel to the ground, start cutting process by moving the handle right to left and back to right.
3. Move the cutter wheel over the stump, removing 1/2
”
to 3/4
”
with each pass
of the cutter wheel (See figure 3)
DO NOT TAKE LARGE PASSES.
DOING SO MAY BOG DOWN THE ENGINE.
Fig.3: Proper method of grinding down tree stumps
4. Verify that only the safe area of the cutter wheel
is in use for cutting (Figure 4)
Fig.4: Safe cutting zone on cutter wheel.
Use only the safe cutting zone of the cutter wheel
to cut and grind stumps (see Figure 4).
Cutting with any other portion of the cutter wheel
may result in operator injur y or damage to the
machine.
14