Relative dimmers
A long press on any of the buttons starts an increase / decrease light intensity operation. A
dimming command will be sent to the dimmer actuator through the
Relative dimming control
communication object, requesting that the light intensity is increased (or decreased) by the
amount defined by the
Dimming step
parameter. When the button is released, however, a “stop”
command will be sent to the dimmer; if the dimming operation was still in progress, it will be
interrupted.
Note
It is common to set the
Dimming step
to 100%. This way, a long press on any of the buttons
will initiate a dimming operation which spans the entire dimming range, all the way up to
100% or down to 0%. As soon as the light intensity reaches the desired value, the user
can release the button and the dimming operation will be interrupted.
Absolute dimmers
A long press on any of the buttons will bring up a window with a regulation bar. The regulation
bar allows precise selection of light intensity values (0...100%). The selected value will be sent
to the bus through the
Absolute dimming control
communication object.
3.4
Control Pages
74
