1
2
56
9. Care and maintenance
For all work on the grinding machine, the locally applicable safety and
accident prevention regulations as well as instructions in the “Safety”
and “Important notes” section of the operating instructions must be
observed.
CAUTION
9.1 Cleaning
Clean the grinding machine and copy grinding device each time after sharpening to prevent the
grinding sludge from drying, hence making it harder to remove. There is a wash brush on the rear
side of the grinding machine for this.
After cleaning, lightly grease the grinding machine and copy grinding device with non-corrosive
oil. See also the lubrication schedule, chapter 9.2.1.
The coolant must be replaced on a weekly basis, and the container must also be cleaned.
ATTENTION
Do not spray-wash the grinding machine
with water. This can damage the grinding
machine!
The finned brush does not work when wet.
9.2 Lubrication and maintenance
The flow gauge (9-1/1) must be removed and
cleaned 1x monthly.
To do so, disconnect the plug (9-1/2) and turn the
flow gauge counter-clockwise by hand using a hex
key. Clean the measuring probe with a clean cloth.
Lubricate the threading slightly (not the probe)
and rotate back down.
Installation is carried out in the opposite direction.
Figure 9-1
Flow gauge
