36
Figure 7-12
Changing the copy grinding plate
Figure 7-13
Control panel
1
2
7.4 Replacing the copy grinding plate
Never change the copy grinding plate when the knife is clamped.
There is a rick of becoming crushed and entangled in the drive pinion.
Serious injury may result.
Press the “Change copy grinding plate” button (3-8/5) only when the
copy grinding plate is mounted.
CAUTION
Loosen the star handle (7-12/1).
Remove limit switch cam (7-12/2).
Set the “Manual / Automatic” selector switch (7-
13/2) to “Manual” and hold the “Change copy
plate” button (7-13/1) until the copy grinding
plate can move no further.
The direction in which the copy grinding plate is
moving can be changed by repeatedly pressing
the “Change copy plate” button (7-13/1).
Allow the plate to run endlessly right. Release the
button after the copy grinding plate has run com-
pletely out; the drive will stop immediately.
Remove copy grinding plate manually without
tilting drive pinion and store carefully.
Lay the new copy grinding plate onto the drive
pinion, press the “Change copy plate” button
(7-13/1) and hold until the copy grinding plate is
approximately in the middle.
With the pin in front, push the limit switch cam
(7-12/2) under the copy grinding plate and tighten
the star handle (7-12/1).
7. Operation
2
1
