33
7.3.3 Setting the grinding angle
Set the grinding angle with the handwheel
(7-7/2).
The grinding angle is read on the scale (7-7/1) at
the point at which it leaves the machine housing.
7.3.4 Switching on the USK 230 grinding machine
Set the switch for the wet-grinding belt (7-8/1)
and the coolant pump (7-8/2) to “I” on the
USK 230 control panel.
The wet-grinding belt and finned brush will start
rotating and the coolant pump is switched on.
7.3.5 Starting the grinding process
Set the copy grinding device to “Automatic” using
the “Manual / Automatic” selector switch (7-9/4).
Select desired grinding program (see chapter 8.2)
and press “Start / Stop” button (7-9/1).
If the wet-grinding belt and coolant pump are not
running, switch them on as described in chapter
7.3.4.
Press the “Start / Stop” button (7-9/1) again.
The copy grinding plate will run to its initial
position and lower to the wet-grinding belt. The
“Start / Stop” button (7-9/1), “Knife feed forward”
button (7-9/2), and “Knife feed back” button (7-
9/3) will flash.
Figure 7-7
Setting the grinding angle
Figure 7-9
Control panel
Figure 7-8
Control panel USK 230
1
4
1
3
2
2
7. Operation
2
1
