Kleenmaid KCGCT6010, Инструкция по использованию и гарантийные обязательства

Страница: 14 / 28

12
To adjust the minimum of the gas burner:
Switch on the burner to adjust and wait few minutes of work with the knob at
maximum position.
Take off the knob and, it depend of the model, insert a small screw driver in
the central hole of the burner tap ( drawing 11 ) and operate increasing or
decreasing ( to open or to close) the pressure on the regulation screw or, in
other models, do the same on the regulation screw situated in the side of the
tap you can meet trough the hole on the working top ( drawing 11A)
Flame must be of sufficient size to be stable on all burner ports. If flame
adjustment is needed, adjust ONLY on the LOW setting. Never adjust flame
size on higher setting.
NOTE: All gas adjustment should be done by autorised service
personnel only.
Before Leaving
Check all connections for gas leaks with soap and water. DO NOT use a
naked flame for detecting leaks. Ignite all burners both individually and
concurrently to ensure correct operation of gas valves, burners and ignition.
Turn gas taps to low flame position and observe stability of the flame for each
burner individually and concurrently. When satisfied with the hotplate, please
instruct the user on the correct method of operation. In case the appliance
fails to operate correctly after all checks have been carried out, refer to the
authorised service provider in your area.
GAS AND ELECTRIC COOKTOP TECHNICAL DATA
Burner
Reduced rate
(MJ/h)
Nominal gas type rate
(MJ/h)
Injector SIZE
(mm / 100)
Natural
Gas
Universal
LPG
Natural
Gas
Universal
LPG
Natural
Gas
Universal
LPG
Rapid 2.18 2.42 10.8 9.7 1.55 85
Semi-rapid 1.49 1.38 6.3 5.6 1.18 65
Auxiliary 0.83 1.30 4.0 3.2 0.90 50
DIMENSIONS OF THE APPLIANCES, Fig. 6
MODEL Width Height Depth
(mm) (mm) (mm)
KCGCT6010
580 30 -76 500