Kleenmaid KCGCT6010, Инструкция по использованию и гарантийные обязательства

Страница: 12 / 28

10
GAS SUPPLY
There are two ways to carry out the connection to the main gas line:
A. The hotplate can be connected with rigid pipe as specified in AS5601 table
3.1.
B. The hotplate can be connected with a Flexible Hose, which complies with
AS/NZS 1869 (AGA Approved), 10mm ID, class B or D, no more than 1.2m
long and in accordance with AS5601. Ensure that the Hose does not contact
the hot surfaces of the hotplate, oven, dishwasher or other appliance that
may be installed underneath or next to the hotplate. WARNING: Ensure that
the hose assembly is restrained from accidental contact with the flue or flue
outlet of an underbench oven. The hose should not be subjected to abrasion,
kinking or permanent deformation and should be able to be inspected along
its entire length. Unions compatible with the hose fittings must be used and
connections tested for gas leaks. The supply connection point shall be
accessible with the appliance installed.
The hose assembly shall be suitable for connection to a fixed consumer
piping outlet located at a point 800mm to 850mm above the floor and in a
region outside the width of the appliance to a distance of 250mm.
Make sure correct gas type and pressure inlet are in accordance with
appliance manufacturing settings.
a) A gas cut-off valve should be put in an accessible location in the supply
line ahead of the range, for turning on and turning off gas supply. If hob is
to be connected to house piping with flexible or semi-rigid metal
connectors for gas appliances, connectors nuts must not be connected
directly to pipe threads. The connectors must be installed with adapters
provided with the connector.
b) The house piping and/or cooktop connector used to connect the cooktop
to the main gas supply must be clean, free of metal shavings rust, dirt and
liquids (oil or water). Dirt, etc in the supply lines can work its way into the
cooktop manifold and in turn cause failure of the gas valves or controls
and clog burners and/or pilot orifices.
c) Turn off main gas valve at meter.
d) Before connecting cooktop apply pipe thread compound approved for LPG
to all threads.