Kleenmaid KCGCT6010, Инструкция по использованию и гарантийные обязательства

Страница: 22 / 28

6
Table 1
Gas Consumption (MJ/h)
Burner Reduced rate
(MJ/h)
Nominal gas type rate
(MJ/h)
Injector SIZE
(mm / 100)
Natural
Gas
Universal
LPG
Natural
Gas
Universal
LPG
Natural
Gas
Universal
LPG
Rapid 2.18 2.42 10.8 9.7 1.55 85
Semi-rapid 1.49 1.38 6.3 5.6 1.18 65
Auxiliary 0.83 1.30 4.0 3.2 0.90 50
FAULT FINDING CHART
WARNING: Before If any damage is found, turn off appliance and call nearest technical assistance centre for
repairing. Do not use appliance in this condition.
FAULT Advice NOTE
All Electrodes do not discharge To check corrected electrical supply
Verify connection of the supply cord is true
Verify the connection of the supply cord is
true on the supply block PA-244
Verify the ignition switch’s assembled on
the valve is correct position.
Remove s.steel plate and verify all internal
electrical wiring. See electrical diagram.
In case electrical connection are
ok, change the ignition block.
Once electrode does not di
discharge To check corrected electrical supply
Verify grease or other impurity present on
the electrodes Remove grease or other impurity
on the electrodes
Remove s.steel plate and verify electrical
connection of the electrodes in to the
ignition block . Connect the electrode in to the
ignition block. If electrode doesn’t
Work, change it.
Burner doesn’t ignite To check corrected electrical and gas
supply
Verify grease or other impurity present on
the burner and electrode (see electrodes
paragraph)
Verify gas leaks if present
See general note and instruction.
Remove gas leaks
Verify gas supply pressure is correct. Connected the manometer on the
test point. See general note and
manual instruction.
Burner turn
s
off Verify if the minimum flame is correct See the adjust minimum gas
burner on the manual instruction
To check gas supply and gas pressure are
correct Connected the manometer on the
test point. See general note and
manual instruction.
Verify gas leaks if present See general note and instruction.
Remove gas leaks.
Verify grease or other impurity present on
the thermocouple near burner. Remove grease or other impurity
on the thermocouple.