KitchenAid KBFA20ER, Техническое образование

Страница: 13 / 68

2-3
Water Pressure
A cold water supply with water pressure of
between 35 and 100 psi (241- 689 kPa) is re-
quired to operate the water dispenser and ice
maker. If you have questions about your water
pressure, call a licensed, qualified plumber.
Reverse Osmosis Water Supply
IMPORTANT:
The pressure of the water sup-
ply coming out of a reverse osmosis system
going to the water inlet valve of the refrigera-
tor needs to be between 35 and 100 psi (241-
689 kPa).
If a reverse osmosis water filtration system
is connected to a cold water supply, the wa-
ter pressure to the reverse osmosis system
needs to be a minimum of 40 to 60 psi (276 -
414 kPa).
If the water pressure to the reverse osmosis sys-
tem is less than 40 to 60 psi (276 - 414 kPa):
Check to see whether the sediment filter
in the reverse osmosis system is blocked.
Replace the filter if necessary.
Allow the storage tank on the reverse os-
mosis system to refill after heavy usage.
If the refrigerator has a water filter, it may
further reduce the water pressure when
used in conjunction with a reverse osmosis
system. Remove the water filter.
If you have questions about the water pres-
sure, call a licensed, qualified plumber.
REFRIGERATOR DOORS
Remove and Replace Handles
1. Using a 3/32
˝
Allen wrench, loosen the
two set screws located on the side of
each handle (see graphics 1 and 2 on
page 2-4).
2. Pull the handle straight out from the door.
Make sure you keep the screws for reat-
taching the handles.
3. To replace the handles, reverse the di-
rections.
•
•
•
Electrical Shock Hazard
Disconnect power before removing
doors.
Failure to do so can result in death or
electrical shock.
IMPORTANT: Remove food and any adjust-
able door or utility bins from the doors.
TOOLS NEEDED:
5/16
˝
, 3/8
˝
, and 1/4
˝
hex-head socket
wrench
#2 Phillips screwdriver
Flat-blade screwdriver
1. Unplug refrigerator or disconnect power.
2. Keep the refrigerator doors closed until
you are ready to lift them from the cabi-
net.
NOTE: Provide additional support for the
refrigerator door while the hinges are be-
ing removed. Do not depend on the door
gasket magnets to hold the door in place
while you are working.
3. Starting with the right-hand side door,
remove the parts for the top hinge, as
shown in Top Hinge graphic on page 2-4.
Lift the refrigerator door from the bottom
hinge pin.
4. Remove the shim from the bottom hinge
pin and keep it for later use (see Bottom
Hinge graphic on page 2-4).
5. Before removing the left-hand side door,
disconnect the wire harness located on
top of the top hinge by wedging a flat-
blade screwdriver or your fingernail be-
tween the two sections (see Wire Har-
ness graphic on page 2-4).
•
•
•
Remove Doors and Hinges