8
VISION 1460 INSTALL GUIDE
4-wire harness
If you do not have a remote start system, DO NOT connect to the Ignition
Switch as shown above. (Also note that Turbo Timers are incompatible!)
NOTE!
GRN
(+)12v Trunk Release Input
This input prevents Arming in RSCM mode and also prevents siren triggers
caused by opening the Trunk while Armed. When connecting (–) WHT trig-
ger input to the Trunk (see page 12), you must also connect this (+) GREEN
input wire as shown in
Fig-2
below.
Connecting the GRN wire allows you to Arm the 1460 and then open the
trunk without triggering the siren. When the trunk opens while Armed,
the shock sensor (as well as any optional sensors you may have added), the
trunk, hood, and doors will be bypassed until the trunk (and all open doors
or hood) is closed.
Note that a Door/Trunk/Hood open condition is determined by a (–) signal
on the WHT input wire or by a (+)12v signal on the “(+)12v Trigger input”
wire. In order for it to activate the bypass functionality while Armed, the (+)
GRN input wire must receive a signal slightly before there is a signal on the
(–) WHT input or the (+)12v Trigger input (or an Ignition-ON signal, when
Remote Start is used).
Don’t Trigger / Don’t Arm Input
IGNITION
SWITCH
OFF
ACC
ON
ST
+12v Control Line
OPTIONAL CONNECTION
for Remote Start Compatibility
DO NOT confuse
with the other
GRN wire in the
3-wire Harness!
Add 1 or 2 diodes
FIG-2: Connections for Trunk Release & Remote Start Compatibility
TRUNK RELEASE
ACTUATOR
GRN
