5
© 2015 KIRAMEK, INC.
arming & disarming
MANUAL DISARMING
You can
manually
Disarm using a secure code in the event your
factory remote’s battery dies (see Note 2 below). The factory
code is “6”, but you can change this code to another number of
your choosing for greater security (see the bottom of this page).
1) Enter the car.
(The siren will blast. You can leave the door open or closed.)
2) Turn ON the Ignition.
3) Within 30s, press the Program Switch the same number of times as
your Disarm Code.
(Factory Default Code = 6)
4) Turn OFF the Ignition.
(The 1460 should Disarm and the siren should
stop.)
1)
If the 1460 won’t Disarm in Step-4 above, you entered the code incor-
rectly. Start over from Step-2.
2)
Many Push Start cars don’t allow the Ignition to be switched on in
the absence of the Factory Remote. So if you lose or destroy your car’s
remote, you may not be able to Manually Disarm the 1460. But if your
factory remote merely has a dead battery, you will be able to switch on
the Ignition and Manually Disarm using the 4 steps above.
NOTES
MANUAL DISARM CODE MODIFICATION
The factory code is “6” but you should change it to another number between 1 & 30:
1)
With the 1460
Disarmed
, switch ON the Ignition.
2)
Press the Program Switch for 6s, until the siren will chirp 3 times.
3)
Release the Program Switch after you hear the 3 chirps, then turn OFF
the Ignition. The Status LED will light for 5s.
4)
Quickly switch ON the Ignition again (while the LED is lit for 5s).
5)
When the LED turns off, wait about 5s and you will see the LED start to
flash.
Take note of the flashes as the number of flashes will be the num
-
ber of your Disarm Code.
Turn OFF the Ignition to program your code.
The LED will then flash the same number of times as your Disarm Code.
If you added any optional VISION transmitters, you must relearn them.
PROGRAMMABLE
