15
© 2015 KIRAMEK, INC.
SHOCK SENSOR 1st STAGE “WARNING” TRIGGER DOESN’T WORK
Examine the shock sensor and look closely at the two LEDs.
When you lightly tap on the sensor, do you ever see a Green LED light?
•
If you never see Green light, adjust the sensitivity knob on the sensor.
•
If after increasing sensitivity you still don’t see the Green LED, it
could be that the suspended element inside the sensor body was shifted
out of place. See page 15 in the
Install Guide
on how to resolve this.
•
If you do see a Green light, the sensor is functioning properly. That
means there is like a wiring problem. Check that the sensor wire har-
ness is properly connected at both ends.
FULL SIREN BLASTS WITH ONLY LIGHT IMPACT TO THE VEHICLE
•
You mounted the shock sensor to metal. Remount on a plastic part.
•
Turn down the shock sensor sensitivity.
•
If you added an optional Ultrasonic sensor, it is very likely that the
controller
of the ultrasonic sensor (not the emitters) was placed too
close to the shock sensor. The Ultrasonic sensor’s
controller
should be
placed more than 30cm (1 foot) away from the shock sensor to avoid
interference.
troubleshooting
