VISION 1460 OWNER’S GUIDE
13
13
programmable features
This feature automatically Rearms the system 60s after it is Disarmed,
unless a Door is opened or the Ignition goes ON during the 60s. Doors will
be locked when the system Rearms.
10
Auto Rearm
When set to
ON
, vehicle parking lights will illuminate for 30s, or until a
Door is opened or until the Ignition is switched ON, in order to illuminate
the area around the vehicle for greater visibility and security.
NOTE
: How the Exterior Illumination lights behave depends on the set-
ting of Feature No. 7, Safety Lights: Flashing or Solid-ON.
17
Exterior Illumination
RESET Programmable Features to Factory Defaults
.
NOTE#1
: You must reprogram all your optional transmitters after Reset.
NOTE#2
: You must know where the 1460 control module is located to Reset.
1.
Disarm and ensure Ignition is OFF.
2.
Disconnect the 1460’s main harness.
(White connector with 6 thick wires.)
3.
Push-and-hold the Program Switch.
4.
Reconnect the 1460’s main harness.
NOTE: The siren will blast.
5.
Release the Program Switch.
NOTE: The siren will stop, LED turns On.
6.
Switch ON the Ignition.
NOTE: Siren will chirp 3 times, LED turns Off.
7.
Switch OFF the Ignition.
NOTE
: LED will light 5s, then flash the same
number of times as your Manual Disarm Code. RESET complete.
To reprogram your optional VISION transmitters (2-way pager or
1-way 3-button remote), consult the manual that came with your
transmitter(s).
NOTE
