1
© 2015 KIRAMEK, INC.
Precautions & Safety
OPERATION
.
Use of the 1460 outside its intended purpose, as described
in this Install Guide and the 1460 Owner’s Guide, could result in damage to
the vehicle or surrounding property, or cause serious injury or even death.
As the installer of this security system, it is your responsibility to ensure
that the vehicle owner is properly informed of all the details of your instal-
lation which are pertinent to safety.
SAFETY POINTS TO ABIDE BY
:
1.
Never start the vehicle’s engine in enclosed spaces that lack adequate
ventilation. Extended exposure to carbon monoxide exhaust fumes
can result in death!
2.
Do not disconnect the vehicle’s battery, as it could cause serious prob-
lems with airbag systems, anti-theft radios or vehicle diagnostics. If
you absolutely must disconnect the vehicle’s battery,
first disconnect
the main power wiring harness of the 1460 and then disconnect the
vehicle’s battery.
3.
Do not proceed with installing this system in vehicles that do not have
a 12-volt electrical system. This system will not function in 24-volt
trucks, and any damage resulting from such installation shall be the
sole responsibility of the installer.
4.
Do not install the 1460 control module or associated sensors in or
near water, or in a location where water could gather. The 1460 is
not waterproof and an electrical short could occur if water gets in-
side.
Only the siren can safely be installed in the engine compart-
ment.
5.
Do not install the 1460 control module in an environment of intense
condensing humidity or steam, in an area with an unusually large
number of airborne particles, or any place where oil could build up
inside the control module case. All of these extreme environments
could lead to an electrical short and possible cause a fire.
6.
Avoid installing the 1460 and its associated sensors near sources of
intense RF transmissions which could possibly interfere with the op-
eration of the system. If you find the system is randomly working and
not working, consider relocating any attached sensors.
