Kipor Sinemaster IG2000i, Руководство по эксплуатации

Страница: 3 / 90

2
Indicates a strong possibility of severe personal injury or death
if instructions are not followed.
Gives helpful information.
If a problem should arise, or if you have any questions about the generator, consult
an authorized dealer.
Our generators are designed to give safe and dependable service if operated
according to instructions. Read and understand the Owner's Manual before
operating the generator. Failure to do so could result in personal injury or equipment
damage.
The Environmental Protection Agency (EPA) recently gave approval for gas stations
to start selling 15% ethanol-blended fuel (E15). E15 gas is now legal for use in cars,
pickups, and SUVs manufactured since 2001. However, E15 IS NOT approved for
off-road engines. This includes engines used in portable generators. Utilizing E15
in outdoor power equipment can cause permanent, irreversible damage, and void
warranties.
The following guidelines will help consumers properly fuel their outdoor power
equipment:
●
Read and follow your owner’s manual. The manual will clearly explain what
fuels can be used to ensure a properly functioning product.
●
Don’t put any fuel containing more than 10 percent ethanol (E10) into small gas
engine products.
●
Check the gas pump to be sure that it is dispensing E10. Some pumps at local
gas stations may offer both E10 and E15, or have blender pumps that dispense
mid-level ethanol fuels for “flex-fuel” automobiles.
●
Higher ethanol fuel (E15) may be less expensive than regular (E10) fuel, but
putting E15 into an E10 approved product could cause product failure and void its
warranty.
●
Ethanol fuel will go through phase separation if not used immediately, (wicking
moisture from the air) so always keep your extra fuel in an airtight container and
try to avoid storing it in a place that is subject to temperature swings.
●
Use a fuel stabilizer if the engine will sit for more than a week without use; this will
help to reduce the ethanol–water separation and potential gumming issues. It is
best to run the engine for at least 20 minutes, under a 50% or more load every 3-4
weeks.