King gates MINIMODUS, Инструкции по установке и использованию, предупреждения

Страница: 11 / 52

11
EN
1. General warnings
• Check that there are no points of entrapment with fixed parts
when the gate leaf is in the maximum opening position; protect
these parts as required.
• The wall control panel must be positioned in view of the
automation, away from its moving parts, at a minimum height
of 1.5m from the ground and not accessible to the public.
• The packaging material of the product must be disposed of in
full compliance with local regulations.
1.3 - Use warnings
• The product should not be used by people (including children)
with physical, sensory or mental disabilities, or lacking
the necessary experience or knowledge, unless they are
supervised by someone responsible for their safety, or have
been fully trained on its use.
• Children playing nearby the automation system should be kept
under constant supervision to prevent them from tampering
with it.
• Do not let children play with the fixed controls. Keep remote
control devices away from the reach of children.
• When cleaning the surface of the product only use a soft damp
cloth. Only use water, without detergents or solvents.
King Gates declines all responsibility for damage to
persons or things that occurred due to causes not directly
attributable to the characteristics of the product and failure
to comply with the installation procedures in accordance
with current regulations.
1.1 - Safety warnings
m
WARNING!
This manual contains important instructions and warnings
for personal safety.
An incorrect installation can cause serious injury. Before starting
work it is necessary to carefully read all the parts of the manual.
If in doubt, suspend the installation and request clarification from
the King-Gates Support Service.
m
WARNING!
According to the most recent European legislation, the
construction of a door or an automatic gate must comply
with the provisions of Directive 98/37/EC (Machinery
Directive) and in particular, the EN 1244, EN 12453, EN
12635 and EN 13241-1 5 standards which allow stating the
alleged compliance of the automation.
In consideration of this, all product installation, connection,
testing and maintenance operations must only be carried
out by qualified and competent technicians!
m
WARNING!
Important instructions: keep this manual for the possible
future maintenance and disposal of the product.
1.2 - Installation warnings
• Before starting the installation, check whether this product
is suitable for automating your gate or door (see chapter 3
and the “Technical characteristics of the product”). If it is not
suitable, DO NOT proceed with installation.
• Install a disconnecting device in the system power supply
network with a contact opening distance that allows complete
disconnection in the conditions stated by overvoltage category
III.
•
All installation and maintenance operations must be
carried out with the automation disconnected from the
power supply.
If the disconnecting device from the power
supply is not visible from the place where the automatism is
positioned, before starting work it is necessary to attach on the
disconnecting device a sign with the inscription “WARNING!
MAINTENANCE IN PROGRESS “.
• During installation, handle the automatism with care, avoiding
crushes, shocks, falls or contact with liquids of any kind.
Do not place the product near heat sources or expose it
to open flames. All these actions can damage it and cause
malfunctions or dangerous situations. If this happens,
immediately suspend the installation and contact King-Gates
Customer Service.
• Do not make changes to any part of the product. Unauthorized
tampering can only cause malfunctions. The manufacturer
declines all liability for any damages deriving from arbitrary
changes to the product.
• If the gate or the door to be automated is equipped with a
pedestrian door, the system must be set up with a control
system that inhibits the operation of the motor when the
pedestrian door is open.