Assembly Instructions
Perks
™
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Service.
Part No. 2040773
Revision B-10
Page 1 of 1
Mobile Screens
Tools Required
■
Hex Head Wrench
■
Rubber Mallet
Package Contents
For Starter Screen:
For Add-on Screen:
■
1 Starter screen
■
1 Add-on screen
■
2 Casters
■
2 Handcuffs
■
2 Handcuff screws
■
1 Caster
Installation
Note:
A basic Screen Assembly consists of a Starter Screen
(2 casters) and an Add-on Screen (1 caster) as a minimum.
1. Place a Starter Screen and an Add-On Screen side by side on
a clean, solid surface or floor; protect screen tubes from
marks and scratches. (Figure A).
2. Place the two sections of the handcuff around the adjacent
top collars at the top of the screen tubes and fasten together
with the handcuff screw as shown. (Figure B). Repeat
procedure for lower connecting collars located above the
casters.
Note:
Additional Add-On Screens may be attached to the basic
assembly by repeating Step 2.
Note:
Over-tightening of the handcuff screws may constrain
the folding capability of the mobile screens.
3. Insert casters into sockets in the bottom of the screen tubes.
Make sure caster fully seats in socket. If necessary, use a
rubber mallet to seat caster.
DO NOT
strike caster with any
other hard object. (Figure C).
Note:
Each Starter Screen must have 2 casters inserted.
Use 1 caster with each add-on screen. There should be only
one caster at each screen connection.
4. Stand assembled unit upright. For safety and stability, make
sure position of screens does not exceed 115˚. (Figure D).
Figure A
Figure B
Starter Screen
Handcuff Screw
(supplied)
Do Not Over-Tighten
Add-on Screen
P
ri
n
te
d
in
U
.S
.A
.
©
2
0
1
0
K
im
b
a
ll
In
te
rn
a
ti
o
n
a
l,
In
c
.
T
8
0
0
.4
8
2
.1
8
1
8
F
8
1
2
.4
8
2
.8
3
0
0
Figure C
Figure D
No more
than 115°
Screen
Connecting
Collars
Top of screen
Handcuff
section
Handcuff
section
1 caster on each
Add-on Screen
2 casters on
Starter Screen
1 caster only
at each screen
connection
