1 x Rebar Ground Stakes
Step 28: Attach Ground Stake to TNR Upright
Hardware
1 x
#12 x 2” Pan Screw
S7
Other Parts
Fig. 28.1
S7
Rebar
Ground
Stake
231
Fig. 28.2
33 cm (13”)
In Ground
Warning! To prevent tipping and avoid potential
injury, stakes must be driven 33 cm (13”) into
ground. Digging or driving stakes can be
dangerous if you do not check first for under-
ground wiring, cables or gas lines.
A:
In the spot shown in fig. 28.1 drive 1 Rebar Ground Stake 33 cm (13”) into the ground against the (231)
TNR Upright. Be careful not to hit the washer while hammering stake into the ground as this could cause the
washer to break off.
B:
Attach the ground stake to (231) TNR Upright just below the t-nut using 1 (S7) #12 x 2” Pan Screw as
shown in fig. 28.2.
C:
After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth
any sharp edges from impact area and touch up with outdoor paint.
T-Nut
61
Содержание Cedar Summit RICHMOND LODGE
Страница 77: ...NOTES 77...