Katadyn Spectra Catalina 340C, Инструкция по установке и эксплуатации

Страница: 46 / 83

46
Membrane Cleaning Procedure
Spectra cleaning compound (SC - 2 or SC - 3) must be mixed with fresh water at a ratio of 1 container of
compound to 3 gallons (12L) of unchlorinated water. A Catalina 340c system requires one container of
compound per cleaning.
1. Close the intake seacock.
2. Push the Fresh Water Flush button to fresh water flush the system. Perform a second fresh
water flush in the same way.
3. Remove the quick disconnect fitting from the brine discharge outlet of the Clark Pump, and
replace it with the quick disconnect brine discharge service hose. Lead it into a 5 gallon (20
liter) bucket. Push the
Fresh Water Flush button and run the feed pump until one gallon of
fresh water runs into the bucket from the brine discharge
service hose. Press
Stop .
4. Remove the hose from the “ To Strainer ” pigtail and install
the inlet service hose from the service kit. Lead both hoses
into the bucket.
5. Make sure that the pressure relief valve on the Clark Pump
is open (un
- pressurized).
6. Mix the cleaning chemical in the bucket. If possible, heat the
solution to 120 F (49 C).
7. Move manual switch on the Feed Pump Module to SERVICE
SYSTEM. The intake service hose will draw solution from the bucket and the brine discharge
service hose will return it. Circulate the solution through the system in this manner for 45
minutes. Stop the pump by moving the toggle switch back to
‘ RUN AUTO ’.
8. If the solution cannot be heated, allow the solution to sit overnight before proceeding to the
next step.
9. Replace the brine discharge overboard hose and run the pump until the bucket is empty by
moving the manual switch to
‘ SERVICE ’. Return the switch to ‘ RUN AUTO ’.
10. Follow the New System Startup procedures to flush the chemicals out of the system (DO NOT
CLOSE the pressure relief valve!)
11. The system may now be restarted, flushed, or stored.
Connecting brine discharge
service hose
Removing hose to sea strainer
from the
“ to strainer ” pigtail.
Attaching intake service hose to
the hose connecting to the sea
strainer.