![background image](http://html1.mh-extra.com/html/katadyn/spectra-catalina-340c/spectra-catalina-340c_installation-and-operating-manual_3650621026.webp)
26
3.
When the Calibration Sequence is complete, press the
button in the upper left corner to return to the
Main Menu.
When prompted by the display, Click
Save
to make
sure that the Calibration is stored in the system
memory.
4.
The Filter Condition has now been calibrated to match your installation.
1.
During the calibration sequence the system will automatically start, begin to make water
for several minutes and then shut itself down.
Make sure that the filters have been
replaced for new, the strainer is clean, and all thru
-
hulls are open before proceeding.
2.
Follow the steps in Figures 1
-
4 below to initiate the Calibration Sequence.
Sensor Calibration
Many of the settings on your system have been pre
-
calibrated during standard factory testing,
however, there are a few settings that will vary based on the installation, vessel, and other
onboard conditions.
If the system has just been installed you must calibrate the Prefilter
Condition before proceeding.
This procedure does
not
need to be done with each filter change under normal operation, it
should
ONLY BE DONE IF THE FILTER CONDITION WON
’
T RESET TO 100% WITH NEW FILTERS
AND A CLEAN/NEW STRAINER SCREEN.
Prefilter Condition Calibration
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Содержание Spectra Catalina 340C
