Kasei KZ-4000MT-PRO-2S, Руководство владельца/оператора

Страница: 43 / 118

34
USING THE UNIT
Preparations:
●
Wear suitable protective clothing,observe safety precautions.
●
Adjust telescoping shaft to the
required length .
●
Starting the engine.
●
Put on the shoulder strap.
Cutting Sequence:
To allow branches a free fall, always cut the lower branches first. Prune heavy branches (large
diameter) in several controllable pieces. Never stand directly underneath the branch you are
cutting – be wary of falling branches. Note that a branch may spring back at you after it hits the
ground – risk of injury. Remove branches in sections
Disposal:
Do not throw cuttings into the garbage can – they can be composted.
Working Techniques:
Hold the control handle with your right hand, and the shaft with your left
hand.Your left arm should be extended to the most comfortable position.
Always hold the shaft with your left hand in the area of the handle hose.
The shaft should always be held at an angle of 60° or less.The least tiring
working position is a tool angle of 60°.Any lesser angle may be used to suit
the situation concerned.
WARNING!
When you use the machine,if the saw chain is locked by the branch,you must move over the
saw and then saw the branch over again .
Cross-cut:
To avoid pinching the bar in the cut,position the cutting attachment with the
hook against the branch and then perform the cross-cut from the top downwards.
Relieving cut:
To avoid tearing the bark on thick branches, always start by performing a
relieving cut (1) on the underside of the branch. To do this, apply the cutting
attachment and pull it across the bottom of the branch in an arc as far as the
bar nose.Perform the cross-cut (2) – position the bar with the hook against
the branch and then perform the crosscut.
Flushing-cutting thick branches:
If branch diameter is more than 4 in (10 cm), first perform undercut (3)
and thencross-cut at a distance of about 8 in./20 cm (A) from the final cut.