Kasei KZ-4000MT-PRO-2S, Руководство владельца/оператора

Страница: 55 / 118

46
Engine Management
Cleaning the Air Filter:
●
Accumulated dust in the air filter will reduce engine efficiency. Increase fuel consumption and
allow abrasive particles to pass into the engine. Remove the air filter as often as necessary to
maintain in a clean condition.
●
Light surface dust can readily be removed by tapping the filter. Heavy deposits should be washed
out in suitable solvent.
●
Remove filter cover by loosening air filter cover knob.
WARNING!
Always have your servicing dealer to adjust the carburetor.Do not adjust the
carburetor by yourself.
Spark Plug:
If engine is down on power, difficult to start or runs poorly at idling speed, first check the spark plug.Fit a
new spark plug after approx. 100 operating hours or earlier if the electrodes are badly eroded.Wrong fuel
mix (too much engine oil in the gasoline), a dirty air filter and unfavorable running conditions (mostly at
part throttle etc.) affect the condition of the spark plug. These factors cause deposits to form on the insulator
nose which may result in trouble in operation.
Removing the spark plug:
●
Move the slide control to STOP.
●
Pull off the spark plug boot (1).
●
Unscrew the spark plug.
Checking the Spark Plug:
●
Clean dirty spark plug.
●
Check electrode gap (A) and readjust if
necessary see"Specifications".
●
Use only resistor type spark plugs of the
approved range.Rectify problems which have caused fouling of spark
plug:– Too much oil in fuel mix.– Dirty air filter.– Unfavorable running
conditions,e.g. operating at part load.
WARNING!To reduce the risk of fire and burn injury,use only spark plugs
authorized by us. Always press spark plug boot (1) snugly onto spark plug
terminal (2) of the proper size. (Note: If terminal has detachable SAE adapter
nut, it must be attached.) A loose connection between spark plug boot and
ignition wire connector in the boot may create arcing that could ignite combustible
fumes and cause a fire.
Installing the spark plug:
●
Screw the spark plug (2) into the cylinder and fit the boot (1) (press it down
firmly).