Kasei KZ-4000MT-PRO-2S, Руководство владельца/оператора

Страница: 40 / 118

31
Check for fuel leakage while refueling and during operation. If fuel leakage is found, do
not start or run the engine until the leak is fixed and any spilled fuel has been wiped away.Take care
not to get fuel on your clothing.If this happens, change your clothing immediately.
National regulation can restrict the use of the pruner.
It is needed for daily inspection before use and after dropping or other impacts in order to
identify any significant damager or defects.
Unit vibrations can cause an improperly tightened fuel filler cap to loosen or come off and
spill quantities of fuel. In order to reduce the risk of fuel spillage and fire, tighten the fuel filler cap
by hand as securely as possible.
To reduce the risk of fire and burn injuries, start the engine
at least 10 feet (3 m) from the fueling spot, outdoors only.Start
and operate your pole pruner without assistance.For specific
starting instructions, see theappropriate section of your manual.
Proper starting methods reduce the risk of injury.Place the pole
pruner on firm ground or other solid surface in an open area or,
in the alternative, as shown in the above picture. Maintain good
balance and secure footing.
Always hold the unit firmly with both hands on the handles while
you are working. Wrap your fingers and thumbs around the handles.
Place your left hand on the shaft and your right hand on rear grip and
throttle trigger. Left-handers should follow these instructions, too.
Keep your hands in this position to have your pole pruner under control
at all times.
Never attempt to operate your power tool with one hand. Loss of control of the power tool
resulting in serious or fatal injury may result.
Danger! Your power tool is not insulated against electric shock.
To reduce the risk of electrocution, never operate this power tool in the
vicinity of any wires or cables (power, etc.) which may be carrying electric
current.
The power tools are equipped with a catalytic converter, which is designed to reduce the
exhaust emissions of the engine by a chemical process in the muffler. Due to this process, the
muffler does not cool down as rapidly as conventional mufflers when the engine returns to idle or is
shut off. To reduce the risk of fire and burn injuries,the following specific safety precautions must
be observed.