Kasei KZ-4000MT-PRO-2S, Руководство владельца/оператора

Страница: 79 / 118

68
CUTTING WITH A NYLON HEAD
Line head rotates in a counter CLOCKWISE direction.The CUT-OFF KNIFE will be on the
right side of the debris shield.
WARNING DANGER
The proper debris shield must be in place on the unit when nylon cutting line is used. The cutting
line can flap around if too much line is exposed. Always use the plastic debri shield with cut-off
knife when using nylon cutting heads.
For nearly all cutting, it is good to tilt the line head so that contact is made on the part of the line
circle where the line is moving AWAY from you and the debris shield. (See appropraite picture)
This results in the debris being thrown AWAY from you.
WARNING DANGER
Tilting the head to the wrong side will shoot the debris TOWARDS you.If the line head is held
flat to the ground so that cutting occurs on the whole line circle, debris will be THROWN at
you, drag will slow the engine down, and you will use up a lot of line.
WARNING DANGER
Use only quality nylon monofilament line of the diameter 2.5mm. Never use wire or
wire-reinforced line in place of nylon trimmer line. Load your nylon line cutting head only with
nylon trimmer line of the proper diameter.
WARNING DANGER
Use extreme caution when operating over bare spots and gravel,because the line can throw small
rock particles at high speeds.Debris shields on the unit cannot stop objects which bounce or
ricochet off hard surfaces.