Kaleidescape Part No. 101-0105-00 Rev 5
Page 52
Kaleidescape Premiere Line Installation Guide
Physical Installation
4. Verify that there is adequate airflow around the player [1 in. (2.5 cm) in
front and 2 in. (5 cm) in back, minimum].
Note:
The mini player automatically turns off if it becomes too hot.
5. Prepare mounting holes. Place the bracket or bracket template against
the wall and mark the locations of the four holes.
6. Drill holes for fasteners. If the surface is wood or a similar material, drill
a 3/32 in. (2 mm) pilot hole at each location.
7. Check that the mounting screws are the appropriate length. Do not use
the screw anchors for wood.
a. If mounting on drywall (hollow wall) or masonry (solid wall), drill a
3/16 in. (5 mm) hole for the screw anchors. Insert the anchors and
tap with a hammer until anchors are flush with the surface.
b. If mounting the power supply with the player, repeat steps for the
power supply bracket.
Do NOT lengthen
DC power cable
4 ft
(1.2 m)
Extend the
AC power cables
as needed
Power Supply
2 in. (5 cm) min.
clearance in the back
0.5 in. (1.3 cm) min. clearance
for side vents
1 in. (2.5 cm) min.
clearance in front
Invert bracket for mounting
orientation with connectors up
