KAESER M135 SIGMA CONTROL MOBIL, Руководство по обслуживанию, Страница: 33 / 288

WARNING
Danger of injury from hot, rotating and electrically live components!
Serious injury can be caused by touching such components.
➤ Operate the machine only with closed doors/canopy.
➤ Carry out maintenance and checks only with the machine shut down.
Transporting
➤ Shut down and fully disconnect the machine before transporting it.
➤ Allow transportation only by personnel trained in safely dealing with motor vehicles and the trans‐
porting of goods.
➤ Ensure that no persons are on the machine when transporting.
➤ Follow local traffic regulations when towing the compressor on public roads.
➤ Follow the ground rules for safe towing:
■ The maximum permissible load for the towing vehicle coupling and the maximum coupling
load given for the machine must not be exceeded.
■ Avoid causing a shift in the centre of gravity by an excessive or incorrectly distributed load.
■ Do not tow in such a way as to impose excessive stress on the machine or chassis.
■ Adjust towing speed to accommodate ground conditions. This applies particularly on bends
and corners.
➤ The towbar must be parallel with the ground otherwise towing instability can develop, resulting
in damage to the machine and/or towing vehicle.
➤ Before moving the machine, make sure any security devices (e.g. anti-theft chain) are released.
➤ When the machine is lifted by a crane, the safety regulations relating to the crane and lifting slings
must be observed.
■ Do not enter the danger zone while the machine is being lifted.
■ Never lift the machine over people or occupied buildings.
■ Secondary or attached loads may not:
─ cause excessive loading on the machine's lifting point (lifting eye),
─ adversely influence the machine's centre of gravity so that it hangs out of square.
■ Use only lifting slings that are suitable for the loads to which they will be subjected.
■ Use only hooks and shackles that comply with local safety regulations
■ Do not attach cables, chains or ropes directly to the machine's lifting eye.
■ Never tamper with the machine's lifting eye or its fixing.
■ Avoid jerking when lifting, as this may damage components.
■ Loads must be slowly lifted and carefully set down.
■ Never allow the load to hang from the crane longer than necessary.
➤ The following are forbidden:
■ transporting by slinging beneath a helicopter,
■ dropping by parachute.
Positioning
➤ Do not position the machine directly against a wall. A build up of heat from the exhaust can
damage the machine.
3 Safety and Responsibility
3.5 Dangers
No.: 9_6975 00 E
Service Manual Screw Compressor
M135 SIGMA CONTROL MOBIL
21