KAESER M135 SIGMA CONTROL MOBIL, Руководство по обслуживанию

Страница: 121 / 288

Fig. 51 Cleaning the filter element
1
Compressed air gun with blast pipe bent to 90° at the end
2
Filter element
➤ Open both doors.
Checking contamination of the air filter
Air filter maintenance is necessary when the yellow piston inside the maintenance indicator reaches
the red zone.
➤ Check the air filter maintenance indicator.
If the yellow piston reaches the red zone, clean or renew the filter element.
Cleaning the air filter
1. Release the retaining clip. Lift off the cap and extract the element.
2. Clean the inside of the housing, the cover and sealing faces carefully with a damp cloth.
3. Clean the filter element
■ Use dry compressed air (≤ 5 bar) at an angle to blow dirt from the element from inside to
outside.
■ The blast pipe must be long enough to reach right into the element.
■ The tip of the blast pipe should not be allowed to touch the element.
■ Clean sealing faces.
4. Inspect the element carefully for any damage.
Renew a damaged element.
5. Insert the cleaned or new filter element into the filter housing. Make sure it is properly in place
and sealed by its gasket.
6. Replace the cap and secure with the clip.
Resetting the maintenance indicator
➤ Press the reset knob on the maintenance indicator a number of times.
The yellow piston within the indicator is reset and the maintenance indicator is ready for use
again.
➤ Close the doors.
10 Maintenance
10.4 Engine
No.: 9_6975 00 E
Service Manual Screw Compressor
M135 SIGMA CONTROL MOBIL
109