28
Self-cleaning
During the self-cleaning function, the oven heats to about
500 °C. In this way, baking and cooking remains are burned
and only ash remains have to be cleaned from the oven.
There are three cleaning levels available.
The more intense and old the dirt, the higher the self cleaning
level used. The inside of the oven only has to be cleaned once
every two or three months. Complete cleaning requires
approximately 2.5 - 4.7 kilowatt-hours.
Suggestions and warnings
For safety reasons, the oven door locks automatically. The oven
door can be opened once again when the inside of the oven
has cooled a little and the lock symbol switches off. Do not
attempt to move the latch by hand.
Do not attempt to open the oven door during self-cleaning.
Otherwise, cleaning will be interrupted.
The oven light does not switch on during self-cleaning.
ã=
Risk of fire!!
The outside of the oven heats up considerably. Keep the front
of the oven clear. Do not place flammable objects, such as
dishcloths, on the door handle. Keep children away.
Before using the self-clean function
The oven must be empty. Remove all pans and unsuitable
accessories from inside the oven.
Clean the oven door and the side surfaces inside the oven
around the area with seals.
ã=
Risk of fire!!
The remains of food and grease as well as roasting juices can
catch fire. Use a damp cloth to clean the inside of the oven and
the accessories that will be cleaned inside the oven.
Cleaning of the accessories
For optimum cleaning of the oven interior, it is recommended
that the self-clean function is not used with the trays.
However, the universal deep enamel tray or the flat enamel
oven tray can only be cleaned using the self-clean function on
level 2.
The shelf should not be cleaned using the self-clean function.
Use water to clean food remains, oil and roasting juices from
the accessories.
ã=
Significant health risks!
Do not place non-stick baking tins or trays in the oven during
self-cleaning. The intense heat removes the non-stick surface
and creates toxic gases.
Setting
Once the cleaning level has been selected, set the oven.
1.
Select the self-cleaning function with the function control
knob
V
.
2.
Set the required cleaning level using the
@
or
A
sensors.
The display panel will show the cleaning level and the
x
symbol. Self-cleaning starts within a few seconds.
The oven door locks shortly after the function has started. The
display panel displays
H
. Only when the
H
symbol turns off
can the oven door be opened again.
Self-cleaning has ended.
The display panel will show
‹‹
:
‹‹
. The oven will stop heating.
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H
symbol on the display panel turns off.
Changing the cleaning level
The cleaning level cannot be changed once it has started.
Stopping the self-cleaning
Turn the function control knob to the zero setting. The oven
switches off. The oven door can be opened again when the
H
symbol on the display panel turns off.
Delaying the end time
The oven allows you to programme the self-cleaning end time.
Self-cleaning can therefore be programmed at night for
example, leaving the oven free for use during the day.
Programme as described in section 1 and 2. Before starting the
self-cleaning, press the
0
sensor three times and delay the
end time with the
@
or
A
sensors.
The oven is set to standby. The display panel will show the
cleaning level and the
y
symbol. When self-cleaning starts, the
cleaning level and the
x
symbol are shown. The
y
symbol
switches off.
Viewing the time settings
To view the duration of the cleaning level or the end time of the
self-cleaning press the
0
sensor repeatedly until the required
symbol lights up. The corresponding value will be shown for a
few seconds on the display panel.
After using the self-clean function
Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
Level
Cleaning level
Duration
‚
mild
approx. 1 hour, 15 minutes
ƒ
medium
approx. 1 hour, 30 minutes
„
intense
approx. 2 hours
