Juniper SRX5600, Руководство по оборудованию

Страница: 253 / 483

Figure 114: Removing an AC Power Supply
Installing an SRX5600 Services Gateway AC Power Supply
To install an AC power supply (see Figure 115 on page 257 ):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Move the AC switch next to the appliance inlet on the power supply to the off position (O).
3. Using both hands, slide the power supply straight into the chassis until the power supply is fully seated
in the chassis slot. The power supply faceplate should be flush with any adjacent power supply faceplate
(see Figure 115 on page 257 ).
4. Tighten both captive screws at the bottom of the power supply.
5. Attach the power cord to the power supply.
6. Route the power cord along the cable restraint toward the left or right corner of the chassis. If needed
to hold the power cord in place, thread plastic cable ties, which you must provide, through the openings
on the cable restraint.
256