Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1, Руководство по установке

Страница: 148 / 244

Checking if system meets RAM requirement....................ok
Checking for sufficient disk space..........................ok
Noting OS name..............................................ok
Stopping any running servers
########## EXTRACTING PAYLOADS ##########
Extracting and decompressing payload........................ok
Extracting license manager package..........................ok
########## GATHERING INFORMATION ##########
1) Install Device Server only
2) Install GUI Server only
3) Install both Device Server and GUI Server
Enter selection (1-3) []> 1
Enter base directory location for management servers [/usr/netscreen]>
Enable FIPS Support? (y/n) [n]>
########## GENERAL SERVER SETUP DETAILS ##########
Will this machine participate in an HA cluster? (y/n) [n]> y
Is this machine the primary server for the HA cluster? (y/n) [y]> n
WARNING: The servers need to be stopped on the primary server
during the installation of this software to avoid data corruption.
########## DEVICE SERVER SETUP DETAILS ##########
Will the Device Server data directory be located on a shared disk partition? (y/n)
[n]>
The Device Server stores all of the user data under a single directory.
By default, this directory is /var/netscreen/DevSvr. Because
the user data (including logs and policies) can grow to be quite
large, it is sometimes desirable to place this data in another
partition.
Please enter an alternative location for this data if
so desired, or press ENTER for the location specified in the
brackets.
Enter data directory location [/var/netscreen/DevSvr]>
Enter the ID assigned by the GUI to this Device Server (1-65535) []> 2
Enter the one-time password for this Device Server
Enter password (password will not display as you type)>
Please enter again for verification
Enter password (password will not display as you type)>
To enable the Device Server to communicate with the GUI Server, you must
provide the IP address of the running GUI Server
Enter the IP address of the running GUI Server []> 10.150.41.10
########## HIGH AVAILABILITY (HA) SETUP DETAILS ##########
Enter the IP address for the primary HA Server []> 10.150.41.7
Enter the IP address for the secondary HA Server [10.150.41.8]>
NOTE: Please make sure the heartbeat PASSWORD is the same for primary and
Copyright © 2010, Juniper Networks, Inc. 126
Network and Security Manager Installation Guide