Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1, Руководство по установке, Страница: 75 / 244

Prerequisites
Perform the prerequisite steps described as if you were installing the management system
on the same server. See “Prerequisite Steps” on page 24 for more information.
Installing the GUI Server
The installer guides you through all the steps required to configure system parameters,
and then the installer runs to completion.
To install the GUI Server:
1.
Navigate to the directory where you saved the installer file.
2.
Run the installer.
On Linux, run the following command:
sh nsm2010.4_servers_linux_x86.sh
On Solaris, run the following command:
sh nsm2010.4_servers_sol_sparc.sh
The installation performs a series of preinstallation checks to ensure that:
• The OS version and specified architecture are compatible.
• You are installing the correct software for your operating system.
• All of the needed software binaries and packages are present.
If any component is missing, the installer displays a message identifying the missing
component:
Checking for platform-specific packages.....................FAILED
The Following list of Packages are Required for NSM installation.
Please install the system update utility before continuing.
chkfontpath
• You have the correct version of the PostgreSQL database.
•
You have correctly logged in as root and that the NSM user exists. The installer
creates the NSM user, if it does not already exist.
•
For Linux servers, the installer checks whether iptables is running. If not, then the
installer continues.
If iptables is running, the installer displays a message similar to the following:
Checking for iptables service………………………ok
Iptables is found to be running on the system. Please make sure the ports
7801 7802, 443, 7800, 7804 are open and available for NSM to run.
Please press enter to continue:
53 Copyright © 2010, Juniper Networks, Inc.
Chapter 4: Installing NSM in a Distributed Configuration