Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1, Руководство по установке, Страница: 180 / 244

Upgrading to NSM 2010.4 Release on an NSM Central Manager Appliance (Online mode)
This section describes upgrading to NSM 2010.4 on an NSM Central Manager appliance
if the appliance is connected to the Internet.
NOTE: NSM 2010.4 for Central Manager does not require a license file.
Use the following procedure to upgrade to NSM 2010.4 on an NSM CM appliance.
1.
From the NSM Software Download page, click the Central Manager upgrade link to
download the NSM Central Manager Appliance software. The downloaded file has
the name
nsm2010.4_servers_upgrade_cm.zip
.
2.
Copy this file onto your NSM CM appliance using FTP or SCP.
3.
Log in as the admin user, and answer n when prompted to run the setup wizard.
4.
Enter sudo su - and enter the admin password to gain root access.
5.
Confirm that the unzip utility is present on the NSM CM appliance by entering the
following command:
which unzip
This command gives you the location of the unzip utility. If it is not available, use the
following command to install this utility:
yum install unzip
6.
Navigate to the directory where you saved the downloaded file, which is typically the
/tmp/ subdirectory.
7.
Enter the following command to unzip and save the two files
(
nsm2010.4_servers_cm.sh , upgrade-os.sh ) and a directory ( apps-rpms ) on the NSM
Central Manager system:
unzip nsm2010.4_servers_upgrade_cm.zip
8.
Enter the following command to automatically start the installation.
sh upgrade-os.sh nsm2010.4_servers_cm.sh
The installer begins a series of preinstallation checks that ensures:
•
You are installing the correct software for your operating system.
•
All the necessary software binaries are present.
•
You correctly logged in as root.
• You have installed a version of NSM earlier than the current version you are installing.
• The system has sufficient disk space and RAM.
Copyright © 2010, Juniper Networks, Inc. 158
Network and Security Manager Installation Guide