Juniper MX10008, Руководство по оборудованию

Страница: 272 / 361

Stopping vehostd: [ OK ]
Stopping watchdog: [ OK ]
Stopping xinetd: [ OK ]
Sending all processes the TERM signal... [ OK ]
Sending all processes the KILL signal... [ OK ]
Saving random seed: [ OK ]
Syncing hardware clock to system time [ OK ]
Turning off swap: [ OK ]
Unmounting file systems: [ OK ]
init: Re-executing /sbin/init
Halting system...
System halted.
CAUTION: The final output of any version of the request vmhost halt command is
the “The operating system has halted.” Wait at least 60 seconds after first seeing this
message before following the instructions in Step 4 and Step 5 to power off the router.
3. Attach the grounding strap to your bare wrist and to one of the two site ESD points on the chassis.
4. Disconnect power to the router by performing one of the following tasks:
•
AC power supply—Set the enable switch to the OFF (O) position and gently pull out the coupler for
the power cord from the faceplate.
•
DC power supply—Switch the circuit breaker on the panel board that services the DC circuit to the
OFF position.
5. Remove the power source cable from the power supply faceplate:
•
AC power supply—Remove the power cord from the power supply faceplate by detaching the power
cord retainer and gently pulling out the male end of the power cord connected to the power supply
faceplate.
•
DC power supply—Loosen the thumbscrews securing the DC power connector on the power source
cables. Remove the power source cables from the power supply.
6. Remove any remaining cables and optics before removing it from the rack.
SEE ALSO
Connecting AC Power to an MX10000 | 163
274