Juniper JUNOSE 11.2.X BGP AND MPLS, Руководство по настройке

Страница: 381 / 742

Table 72: show mpls Output Fields (continued)
Field Description Field Name
LDP targeted-hello interval, in seconds LDP targeted-hello interval
Status of topology-driven LSP, enabled or disabled Topology Driven LSP
LSPs are placed in the IP routing table for forwarding plain IP traffic;
displayed only when the
mpls ldp ip-forwarding command has
been configured. Indicates whether the LSPs that are used for IP
forwarding are host only, subject to a specified access list, or subject
to a specified prefix list.
LSPs used for IP forwarding
This field and the following fields are displayed only when RSVP-TE
is enabled. RSVP is enabled
IP address of label-switched router LSRID
Frequency at which LSPs are checked for better paths Re-optimization timer
Retry behavior to be performed during LSP setup Tunnel retry
State of RSVP-TE summary refresh reduction, OFF or ON Refresh reduction
State of RSVP-TE summary refresh message bundling, OFF or ON Message bundling
Type of label advertised for the LSR that is the egress router for the
prefix, explicit-null or a non-null label Egress label
State of RSVP-TE hello feature, including the hello refresh interval
and hello miss limit Hellos
State of RSVP-TE graceful restart, OFF or ON Graceful restart
Graceful restart helper mode is enabled when this field is displayed helper mode
Graceful restart time, in milliseconds Restart time
Graceful restart recovery time, in milliseconds Recovery time
Related Topics show mpls
•
Monitoring MPLS Explicit Paths
Purpose Display MPLS explicit paths.
Action To display information about all MPLS explicit paths:
host1:pe2# show mpls explicit-paths
path name/identifier rx1-path enabled
345 Copyright © 2010, Juniper Networks, Inc.
Chapter 5: Monitoring MPLS