Jungheinrich DFG 316, Руководство по эксплуатации

Страница: 48 / 103

E 15
0
406
.GB
3.8 Starting procedure for the DFG
– Put the key in the ignition / starter
switch (19).
– Set the ignition / starter key to the
“ I ” position.
– Press the horn button (27) and
test the horn .
– After setting the ignition / starter
(19) to the I position, the charging
current (3), engine oil pressure
(2), neutral setting (14) and
parking brake (5) indicators and
the preheat (13) control light will
light up.
– Apply the accelerator pedal (22)
fully and wait until the preheat
control light goes out.
Z
The preheat time depends on the
engine temperature, but normally
lasts approx. 4 seconds.
– Set the ignition / starter key now
to the II position.
M
Only apply the starter for a
maximum of15 seconds without
interruption. Before starting again,
wait 30-60 seconds and reset the
ignition / starter switch to
0 .
– Release the key as soon as the
engine starts. It automatically
returns to the
I position.
M
All indicators lights except for
neutral setting (14) and parking brake (5) should go out as soon as the engine starts.
If not, stop the engine immediately and rectify the fault.
14
3 5
2
22
27