Jungheinrich DFG 316, Руководство по эксплуатации

Страница: 74 / 103

F 5
11
0
6
.G
B
Maintenance intervals
Standard
=
t
W A B C
Hydraulic
operation 5.1 Check mast bearings
t
5.2 Check setting of slide pieces and stops, and adjust if
necessary
t
5.3 Visually inspect the mast rollers and check contact
surface wear level
t
5.4 Check lateral clearance of mast connections and of fork
carriage
t
5.5 Check load chain setting and tighten if necessary
t
5.6 Check forks and fork carriage for wear and damage
t
5.7 Check mast tilt angle
t
5.8 Check position of tilt cylinder, check piston head jam nut
is secure and tighten if necessary
t
5.9 Test hydraulic system operation
t
5.10 Check that hose and pipe lines and their connections
are secure, check for leaks and damage, and tighten
connections if necessary.
t
5.11 Check cylinders and piston rods for damage and leaks,
and make sure they are secure
t
5.12 Check hydraulic oil level and top up if necessary
t
5.13 Replace hydraulic oil (this may have to be performed via
a specialist environmental service truck)
t
5.14 Replace the hydraulic oil filter
t
5.15 Replace hydraulic reservoir discharge paper filter
t
5.16 Check attachments and auxiliary equipment are secure,
test operation and check for damage
t
Sign off/
Demonstra-
tion 6.1 Lubricate truck in accordance with Lubrication
Schedule.
t
6.2 Test run
t
6.3 Demonstration after servicing
t
Steering
system 7.1 Test steering
t
7.2 Check mechanical parts of steering column
t
7.3 Check steering axle and steering knuckle for wear and
damage
t
Fitting times 8.1 Enable servicing and inspection by removing/
assembling panels and covers.
t