Art. No. DS 4092 TS
clockwise or anticlockwise direction
It is only visible with "Function =
brightness value transmitter" and only
with enabled value adjustment!
Value on turning
(0...65,535)
0
...65535
This parameter determines the object
value when the rotary knob is turned in
clockwise or anticlockwise direction
It is only visible with "Function = value
transmitter 0...65535" and only with
enabled value adjustment!
Rotation angle for value
adjustment
approx. 36° (3 notches)
approx. 45° (4 notches)
approx. 60° (5 notches)
approx. 72° (10 notches)
During a value adjustment, the rotary
knob must be turned by a defined
number of notches during an operation.
This parameter defines the number of
notches required for the value
adjustment. During an operation of the
rotary knob without value adjustment, a
2-byte value telegram is first transmitted
after the first notch (minimum rotation
angle) regardless of the direction it is
turned. The parameter "Starting value in
case of value adjustment" defines what
value this is (see below). If the number
of notches necessary for the value
adjustment is exceeded during
continuous operation, the device adjusts
the value by the preset step width
depending on the rotation direction and
transmits this to the bus. If the operation
still continues, the value is adjusted
continuously.
This parameter is visible only if the value
adjustment is enabled!
Starting value in case of
value adjustment
same as configured value
same as value after last
adjustment
same as value from
communication object
This parameter defines the original
starting value for the adjustment.
Adjustment can begin from the value
configured in the ETS, from the final
value of the last adjustment cycle or
from the current value of the
communication object (not for
temperature and brightness value
transmitter).
This parameter is visible only if the value
adjustment is enabled! The standard
setting is dependent on the configured
function.
Direction of value
adjustment
Clockwise: upwards /
anticlockwise:
downwards
Clockwise: downwards /
anticlockwise: upwards
Here, it is determined whether the
values should be increased ("upwards")
or reduced ("downwards") depending on
the direction of rotation during the value
adjustment.
This parameter is only visible on
Page 118 of 143
Software "Rotary sensor with extensions 10FE1x"
Parameters
