PAGE 39 of 89
EB0162 Rev 00
3.
Once the cable is placed the entire length of the tube, bring the zipper from
the opposite end to meet at any point in the middle
(Fig. 74)
.
4.
When necessary, the two zippers may be opened to allow any cables to be
routed out of the tube
(Fig. 75)
.
5.8.3. Clamp Setup
If the tube
becomes
disconnected
from the cable
management
dovetail mount,
follow these
instructions to
re-attach the tube and dovetail mount.
1.
Loosen the clamp screw using the
supplied 3 mm hex driver
(Fig. 76)
.
2.
Slide the clamp around the tube
first, and then slide the tube
around the outside of the cable
management dovetail mount
(Fig. 77)
. Align the zipper opening
and the cable management
dovetail mount opening.
3.
Slide the clamp over the tube
and cable management dovetail
mount, pinching the tube in
between
(Fig. 78)
.
4.
Tighten the clamp screw
(Fig. 79)
.
Fig. 74 - Zip opposite end
Fig. 75 - Flexible routing
Fig. 76 - Loosen clamp screw
Fig. 77 - Slide tube around mount
Fig. 78 - Slide clamp onto mount
Fig. 79 - Tighten clamp screw
