Fig 1
Attach the side panels (C) to the front panel (D) with 4 hex
cap bolts, 8 flat washers, 4 lock washer, and 4 hex nuts (E).
Mount the shelf (F) to the inside of the stand with 2 pan head
screws M5 (G) and 2 lock washers.
Finish stand assembly by attaching rear panel to side panels.
Make sure stand is sitting evenly on a level surface before
tightening hardware.
Fig 2
WARNING:
Main unit (A) is 95kg heavy!
Use great care and adequate resources when lifting the unit
up onto the stand (B).
Through the door in the cabinet (E) attach main unit to stand
with two hex cap bolts and two flat washers (D).
Sanding belt installation
Unlock the platen assembly
(A, Fig 3).
Fig 3
Tilt sanding unit to the vertical position, and lock handle.
Remove the belt guards by unscrewing two lock knobs (B Fig
4).
Take out sanding belt and fence packed behind the belt
guard.
Fig 4
Move the handle (C) to the no-belt-tension position.
Place belt on both rollers so that the edge of the belt is even
with the edge of the rollers.
Observe direction arrow on inside of sanding belt. Make sure
that direction arrow on belt matches direction indicator on the
belt cover.
Tension the belt if in place.
Rotate the belt by hand in the direction indicated by the arrow
on the belt guard (If
belt tracking needs adjustment see “Belt
Tracking Adjustment” chapter 8.1)
Drum guard assembly
Attach the drum guard (C, Fig 5) with four M4x20 screws (A).
Two rectangular spacers (D) need to be placed between
hinges (B) and belt cover (E).
Note: Orient the rectangular spacers so the slightly rounded
side sits against the hinge.
Fig 5
Attach the connection plate (F) with 2 washers (G) and 2 lock
knobs (H).