The slotted side of the connection plate attaches to the drum
guard (C).
When opening or closing the drum guard, slightly loosen both
lock knobs.
Extension table assembly
Attach the extension bracket (E, Fig 6) to the side of the
motor (D) with 2 socket head cap screws (F).
Fig 6
Slide the shaft of the extension table (C) into the extension
bracket and tighten with lock knob (G).
5.3 Mains connection
Mains connection and any extension cords used must comply
with applicable regulations.
The mains voltage must comply with the information on the
machine licence plate.
The mains connection must have a 16 A surge-proof fuse.
Only use power cords marked H07RN-F
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
In case of machine overload the motor overload cut-off will
react.
After appr.5 min of cooling the overload cut off can be reset.
WARNING:
The machine will start when you reset the
overload push button! (Only 230V version)
5.4 Dust connection
Before initial operation, the machine must be connected to a
dust extractor. The suction should switch on automatically
when the belt sander is switched on.
The flow rate on the suction port must be 20m/sec.
Flexible hoses must be of non-flammable quality, and must
be connected to the machine ground system.
5.5 Starting operation
You can start the machine with the green on button. The red
button on the main switch stops the machine.
After connecting to the power source, turn on the power to the
machine just enough to start the belt rotating and then turn
off. Do this several times and observe belt tracking.
If adjustment is necessary refer to “Belt tracking adjustment”
(chapter 7.2)
6. Machine operation
6.1 Horizontal sanding
With the sanding platen locked in the horizontal position, the
removable fence (A, Fig 7) may be used.
The fence can be secured in place by screwing two lock
knobs (B) into the guide blocks found in the mitre slot.
Remove the extension table if applicable.
The backstop (C) must be mounted and the drum guard must
be closed.
Fig 7
6.2 Vertical sanding
With the sanding platen (E, Fig 8) locked in the vertical
position, the backstop (C) must be installed.
Remove the extension table if applicable.
The drum guard must be closed.
