MC 11000
(A)
(3)
Adjusting Height of Embroidery Foot P
The space between the needle plate and the bottom surface of the foot (P) should be
0.7 to 1.5 mm when the needle bar is at its lowest position.
(1)
(2)
(4)
24
1. Set the pressure dial at 2 and remove the
top cover.
2. Lower the needle bar to its lowest position and lower
the presser bar lifter.
3. Insert a 0.8 mm thickness gauge (1) between
the embroidery foot P (2) and the needle plate (3).
4. While pressing the presser bar actuator (4) down
against the upper shaft cam, loosen the screw (A)
and push it down in the direction of the arrow, then
tighten the screw (A) again.
5. Reattach the top cover.
(Set the pressure dial at 3.)
NOTE: After this adjustment, Foot sensor adjustment must
be performed. (See page 32)
0,8 mm
(Thickness of Gauge 860G001)
www.promelectroavtomat.ru
