MC 11000
(A)
Main
Slave
DC1
Check Foot/Feed Dog
L
X
L
H
Adjusting Presser Foot Sensor
To adjust foot sensor position
1. Set up the machine in Adjust Mode. Turn the power
witch on while pressing the Start/Stop button and the
reverse button at the same time. (Keep pressing both
buttons until LCD screen shows the adjusting window.)
2. Press the Foot Sensor key on the touch panel.
3. Attach the zigzag foot (3), set the pressure dial at “3”
and lower the feed dog and the presser foot.
4. Lower the needle bar to the lowest position.
5. Loosen the foot sensor shield plate screw (A).
6. Move the foot sensor shield plate (1) to the left-most po-
sition until it touches the sensor (2) lightly. (“L” will ap-
pear on the touch panel.)
7. Remove the zigzag foot (3) and lower the presser bar.
(H will appear on the touch panel.)
To check:
8. Set the pressure dial at 2.
9. Change the foot to embroidery foot P and slowly lower
the embroidery foot P.
10.Turn the handwheel to raise the needle bar to its
highest position.
11. While slightly moving the foot sensor shield plate (1)
within its range of play, check the indication on the
touch panel.
If the screen shows “H”, the foot sensor is properly
adjusted. Press the X key and turn the power switch
off.
If the screen shows “L”, readjust the height of embroi-
dery foot P and proceed with the adjusting steps again
from step 1 to 7.
(1)
(2)
(3)
(4)
34
www.promelectroavtomat.ru
