(A)
(B)
(A)
(B)
Main
Slave
DC1
8 Adjust
88888888
X
INITIALIZE
Adjusting Stretch Stitch Balance
When a stretch stitch is sewn with the feed balancing dial (1) set at the standard setting
mark ì2î, the length should be as indicated with the “ “ mark in the following figure.
If not (if the forward feeding and backward feeding are out of balance), make an adjustment
as follows:
1. Set up the machine in Adjust Mode. Turn the
power switch on while pressing the Start/Stop
button and the reverse button at the same tiem.
(Keep pressing the both buttons until the LCD
screen shows the adjusting window.)
2. Press the 8 Adjust key on the touch panel.
3. Set the feed balancing dial (1) at the standard
setting mark “ “ (2).
4. Check the sewing results.
(The standard length of the consecutive eights is
34 mm (5).
5. Remove the base lid.
6. If the length of the stitch is longer than the
standard length, turn the adjusting screw (4) in the
direction of A.
If the length of the stitch is shorter than the
standard length, turn the adjusting screw (4) in the
direction of B.
7. Check the sewing results.
8. Press the X key and turn the power off.
9. Reattach the base lid (3).
(1) Feed adjusting dial
(2) Setting mark
(3) Base lid (3)
(4) Adjusting screw
(5) Lenght of five eigths (should be 31 to 37 mm)
(1)
(2)
(3)
(4)
(5)
31
33
mm
39
mm
(Gauge 860G001)
www.promelectroavtomat.ru
