127
UMG 96RM-PN
TCP/IP addressing quick guide
Manual TCP/IP settings
Switch to Programming mode:
• Switching to Programming mode is done by pressing
buttons 1 and 2 simultaneously for approx. 1 second.
The symbols for Programming mode "PRG", and for
the current transformer "CT" appear.
Set the TCP/IP address (addr.)
• Use button 2 to switch to "Adr" on the display.
• Use button 1 to select the first digit of the address
(Byte 0) (digit flashes). Select the digit with button 2.
• Select the next digit with button 1 (digit flashes) and
use button 2 to set the desired digit.
• Once Byte 0 of the address is set, bytes 1 to 3 can be
set with button 1. Then the display jumps back to Byte
0 (
none of the digits are flashing).
Subnet mask (SUb)
• Use button 2 to switch to the subnet mask area
and set it with buttons 1 and 2, in the same way as
the address.
Set gateway address (GAt)
• Use buttons 2 and 1 to set the gateway in the same
way as the address.
Exit Programming mode
• Exit the mode by pressing buttons 1 and 2 simultaneously,
or wait for 60 seconds.
Designation
Byte identifier
of the address (e.g. Byte 0)
Address value, Byte 0
Fig. TCP/IP address, Byte 1
A TCP/IP address consists of 4
bytes with the following structure:
xxx.xxx.xxx.xxx
Byte 1
Byte 0
Byte 2 Byte 3
Содержание UMG 96 RM-PN
